The New BT700 Sprint

• Is designed to deliver a flexible & fast clean.

• Is our best selling pass through dishwasher.

• Ideally suited to 75 – 200 seat restaurants.

Flexibility

• Choice of 4 wash cycles, gives this unit the flexibility to handle any wash job.

• Has both top & bottom rotating stainless steel wash & rinse arms for a thorough cleaning of articles.

• Has a large 8.9 kW rinse element to ensure quick recovery time between loads

• Ergonomic bench height design, eliminates bending during loading & unloading

• Has its own separate rinse pump, to ensure a thorough & consistent rinse on every load and allows for installation in low water pressure areas.

• Has efficient hot water use only 3.5litres per cycle

Simplicity

• Easy to operate, simply raise & lower hood to initiate cycles

• Is available in either single phase or 3 phase power.

• Can be installed either in a straight through, front only or corner operation.

• Conforms with Australian Health Regulations.

• Has a safety cut out on the hood for operator safety.

• Has easy to remove scrap trays for ease of cleaning & pump protection.

• Electromechanical controls that are easily replaceable at a low cost.

• Stainless steel impellors are fitted to both the wash & rinse pump, these are resistant to hot water & harsh chemicals.

• Takes the industry standard 500 x 500mm racks

• Made in Australia for Australian conditions.

Download Brochure

MODEL BT700	ELITE SERIES PASS THROUGH SPRINT
Pass through dishwasher	Ergonomic design eliminates bending during loading & unloading
4 wash cycle options	Flexibility to handle any wash job. Up to 700* plates per hour
Available in 3 phase power	Faster recovery & quicker load turnaround
Powerful 560W wash pump	Thorough wash in a large capacity tank
Stainless steel impellor in wash & rinse pump	Does not break down with heat & detergents
Separate rinse pump	Constant sanitizing rinse regardless of incoming water pressure Suitable for medium sized restaurants in low water pressure areas
Straight through, corner or front only installation	Flexible in installation
50mm leg adjustment	Easier installation
Stainless steel cabinet construction	Durability & protection against harsh detergents & hot water
Removable stainless steel scrap trays	Easy daily cleaning & prevents blockages in pump & washarms
Easy service access	Minimum disruption for maintenance
Takes industry standard rack (500 X 500mm)	Will accept up to 12” or 30cm plates
Wash cycles are initiated by lowering hood	Operator friendly & simple to use
Hood safety cut-out switch	Operator safety
2 x plate, 1 x cup & 1 x cutlery racks supplied	No initial accessories to purchase
Water board type tested approved: TT Certificate No: PST 20029	Approved for direct connection to the water supply
Electromechanical controls	Easy to repair at the lowest cost & with minimum disruption