The BT700 Sprint

Is designed to deliver a flexible & fast clean. Is our best selling pass through dishwasher. Ideally suited to 75 – 200 seat restaurants.

Flexibility

Choice of 4 wash cycles, gives this unit the flexibility to handle any wash job. Has both top & bottom rotating stainless steel wash & rinse arms for a thorough cleaning of articles. Has a large 8.9 kW rinse element to ensure quick recovery time between loads Ergonomic bench height design, eliminates bending during loading & unloading Has its own separate rinse pump, to ensure a thorough & consistent rinse on every load and allows for installation in low water pressure areas. Has efficient hot water use only 3.5litres per cycle

Simplicity

Easy to operate, simply raise & lower hood to initiate cycles Is available in either single phase or 3 phase power. Can be installed either in a straight through, front only or corner operation. Conforms with Australian Health Regulations. Has a safety cut out on the hood for operator safety. Has easy to remove scrap trays for ease of cleaning & pump protection. Electromechanical controls that are easily replaceable at a low cost. Stainless steel impellors are fitted to both the wash & rinse pump, these are resistant to hot water & harsh chemicals. Takes the industry standard 500 x 500mm racks Made in Australia for Australian conditions.

• Pass through dishwasher - Ergonomic design eliminates bending during loading & unloading
• 4 wash cycle options - Flexibility to handle any wash job. Up to 700* plates per hour
• Available in 3 phase power - Faster recovery & quicker load turnaround
• Powerful 560W wash pump - Thorough wash in a large capacity tank
• Stainless steel impellor in wash & rinse pump - Does not break down with heat & detergents
• Separate rinse pump - Constant sanitizing rinse regardless of incoming water pressure - Suitable for medium sized restaurants in low water pressure areas
• Straight through, corner or front only installation - Flexible in installation
• 50mm leg adjustment - Easier installation
• Stainless steel cabinet construction - Durability & protection against harsh detergents & hot water
• Removable stainless steel scrap trays - Easy daily cleaning & prevents blockages in pump & washarms
• Easy service access - Minimum disruption for maintenance
• Takes industry standard rack (500 X 500mm) - Will accept up to 12” or 30cm plates
• Wash cycles are initiated by lowering hood - Operator friendly & simple to use
• Hood safety cut-out switch - Operator safety
• 2 x plate, 1 x cup & 1 x cutlery racks supplied - No initial accessories to purchase
• Water board type tested approved: TT Certificate No: PST 20029 - Approved for direct connection to the water supply
• Electromechanical controls - Easy to repair at the lowest cost & with minimum disruption